INA180,INA2180,and INA4180(INAx180) current sense amplifiers are designed for  cost-optimized applications.

The TLV733 series low-dropout linear regulator (LDO) has ultra-small size and low static current, can provide 300mA sourcing current, and has excellent line and load transient performance. This series of devices can provide a typical accuracy of 1%.

TPS54540 is a 42V, 5A, step-down regulator with an integrated high-side MOSFET.

TL431LI / TL432LI is a pin on the pin on the pin. TL43XLI provides better stability, lower temperature drift (VI (DEV)) and lower reference current (IREF), thereby improving system accuracy.

The TPS54531 device is a 28V, 5A non-synchronous step-down converter that integrates a low RDS(onhigh-side MOSFET.

TL431LI/TL432LI is a pin-to-pin replacement of TL431/TL432. TL43xLI provides better stability, lower temperature drift (VI(dev)) and lower reference current (Iref), thereby improving system accuracy.TL431 and TL432 devices are three-terminal adjustable shunt regulators, which can meet the specified thermal stability in the applicable automotive, commercial and military temperature ranges. The output voltage can be set to any value between Vref (approximately 2.5V) and 36V through two external resistors.

The TMP102 device is a digital temperature sensor, which is very suitable as a replacement for NTC/PTC thermistors that require high precision. The device can provide an accuracy of ±0.5°C without calibration or without external component signal conditioning. The device temperature sensor is a highly linear product, and the temperature can be known without complicated calculations or table lookup. The on-chip 12-bit ADC has a minimum resolution of 0.0625°C.

Description  This device contains four independent buffers with  3-state outputs. Each gate performs the Boolean  function Y = A in positive logic.

8-BIT ANALOG-TO-DIGITAL CONVERTERS WITH SERIAL CONTROLThe TLC548 and TLC549 are CMOS analog-to-digital converter (ADC) integrated circuits built around an 8-bitswitched-capacitor  successive-approximation  ADC.  These  devices  are  designed  for  serial  interface  with  amicroprocessor or peripheral through a 3-state data output and an analog input. The TLC548 and TLC549 useonly  the  input/output  clock  (I/O  CLOCK)  input  along  with  the  chip  select  (CS)  input  for  data  control.  Themaximum I/O CLOCK input frequency of the TLC548 is 2.048 MHz, and the I/O CLOCK input frequency of theTLC549 is specified up to 1.1 MHz.

The TL431 and TL432 are three-terminal adjustable shunt regulators, with specified thermal stability over  applicable automotive, commercial, and military temperature ranges. 

The TPS6104x is a high-frequency boost converter  dedicated for small to medium LCD bias supply and  white LED backlight supplies. The device is ideal to  generate output voltages up to 28 V from a dual-cell  NiMH/NiCd or a single-cell Li-Ion battery. The part  can also be used to generate standard 3.3-V or 5-V  to 12-V power conversions.  

The TLC5941 is a 16-channel, constant-current sink,  LED driver. Each channel has an individually  adjustable 4096-step grayscale PWM brightness variations between LED channels and other LED  Controlled In-Rush Current  drivers. Both grayscale control and dot correction are accessible via a serial interface. A single external  resistor sets the maximum current value of all 16   channels.