product
Products
Home /

SEMICONDUCTORS

/

Electronic Components

/

TI

/TI LP8556SQX-E09/NOPB TEXAS INSTRUMENTS

TI LP8556SQX-E09/NOPB TEXAS INSTRUMENTS

LP8556 High-Efficiency LED Backlight Driver For Tablets

  • Brand:

    TI
  • Product Details

1 Features

1• High-efficiency DC/DC boost converter with integrated 0.19-Ω power MOSFET and three

switching frequency options: 312 kHz, 625 kHz,and 1250 kHz

• 2.7-V to 36-V Boost switch input voltage range supports multi-cell Li-Ion batteries (2.7-V to 20-V VDD input range)

• 7-V to 43-V Boost switch output voltage range supports as few as 3 WLEDs in series per channel and as many as 12

• Configurable channel count (1 to 6)

• Up to 50 mA per channel

• PWM and / or I 2C brightness control

• Phase-shift PWM mode reduces audible noise

• Adaptive dimming for higher LED drive optical efficiency

• Programmable edge-rate control and spread spectrum scheme minimize switching noise and improve EMI performance

• LED fault (short and open) detection, UVLO, TSD, OCP, and OVP (up to 6 threshold options)

• Available in tiny 20-pin, 0.4-mm pitch DSBGA package and 24-pin, 0.5-mm pitch WQFN package


2 Applications

LED backlights for tablet LCDs

微信截图_20220803170903.png

3 Description

The LP8556 device is a white-LED driver featuring an asynchronous boost converter and six high precision current sinks that can be controlled by a PWM signal or an I

2C master.

The boost converter uses adaptive output voltage control for setting the optimal LED driver voltages as low as 7 V and as high as 43 V. This feature minimizes the power consumption by adjusting the output voltage to the lowest sufficient level under all conditions. The converter can operate at three switching frequencies: 312 kHz, 625 kHz, and 1250 kHz, which can be set with an external resistor or pre-configured via EPROM. Programmable slew rate control and spread spectrum scheme minimize switching noise and improve EMI performance. LED current sinks can be set with the PWM dimming resolution of up to 15 bits. Proprietary adaptive dimming mode allows higher system power saving. In addition, phase shifted LED PWM dimming allows reduced audible noise and smaller boost output capacitors.

The LP8556 device has a full set of fault-protection features that ensure robust operation of the device and external components. The set consists of input undervoltage lockout (UVLO), thermal shutdown (TSD), overcurrent protection (OCP), up to 6 levels of overvoltage protection (OVP), LED open and short detection.

The LP8556 device operates over the ambient temperature range of –30°C to +85°C. It is available in space-saving 20-pin DSBGA and 24-pad WQFN packages.


Send A Message
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.
If you have questions or suggestions,please leave us a message,we will reply you as soon as we can!

Product Categories

New Products

Related Products
LM321LVIDBVR

TI Operational Amplifier LM321LVIDBVR

The LM3xxLV family includes the single LM321LV,  dual LM358LV, and quad LM324LV operational  amplifiers, or op amps. The devices operate from a  low voltage of 2.7 V to 5.5 V.  

TCA9534APWR

TI TSSOP-16 TCA9534APWR Low power input output (I/O) expander

TCA9534A is a 16-pin device that provides 8-bit general-purpose parallel input and output (I/O) expansion for the two-wire bidirectional I 2C bus (or SMBus) protocol. The device can operate in a supply voltage range of 1.65V to 5.5V, allowing the use of various devices. The device supports 100kHz (standard mode) and 400kHz (fast mode) clock frequencies. When switches, sensors, buttons, LEDs, fans, and other similar devices require additional I/O, I/O expanders (such as TCA9534A) can provide a simple solution.

 TLC5941RHBR

TI VQFN-32_EP TLC5941RHBR LED driver

The TLC5941 is a 16-channel, constant-current sink,  LED driver. Each channel has an individually  adjustable 4096-step grayscale PWM brightness variations between LED channels and other LED  Controlled In-Rush Current  drivers. Both grayscale control and dot correction are accessible via a serial interface. A single external  resistor sets the maximum current value of all 16   channels.

TI TPS61040DBVR 

TI TPS61040DBVR DC-DC IC SOT-23-5

The TPS6104x is a high-frequency boost converter  dedicated for small to medium LCD bias supply and  white LED backlight supplies. The device is ideal to  generate output voltages up to 28 V from a dual-cell  NiMH/NiCd or a single-cell Li-Ion battery. The part  can also be used to generate standard 3.3-V or 5-V  to 12-V power conversions.  

TL431BIDBZR

TI SOT-23 TL431BIDBZR Voltage reference chip

The TL431 and TL432 are three-terminal adjustable shunt regulators, with specified thermal stability over  applicable automotive, commercial, and military temperature ranges. 

TLC549CDR

TI SOP8 TLC549CDR Communication IC

8-BIT ANALOG-TO-DIGITAL CONVERTERS WITH SERIAL CONTROLThe TLC548 and TLC549 are CMOS analog-to-digital converter (ADC) integrated circuits built around an 8-bitswitched-capacitor  successive-approximation  ADC.  These  devices  are  designed  for  serial  interface  with  amicroprocessor or peripheral through a 3-state data output and an analog input. The TLC548 and TLC549 useonly  the  input/output  clock  (I/O  CLOCK)  input  along  with  the  chip  select  (CS)  input  for  data  control.  Themaximum I/O CLOCK input frequency of the TLC548 is 2.048 MHz, and the I/O CLOCK input frequency of theTLC549 is specified up to 1.1 MHz.

 SN74HC125DR

TI SN74HC125DR SOIC-14 15mil driver

Description  This device contains four independent buffers with  3-state outputs. Each gate performs the Boolean  function Y = A in positive logic.

TMP102AIDRLR

TI SOT-256 TMP102AIDRLR Temperature Sensor

The TMP102 device is a digital temperature sensor, which is very suitable as a replacement for NTC/PTC thermistors that require high precision. The device can provide an accuracy of ±0.5°C without calibration or without external component signal conditioning. The device temperature sensor is a highly linear product, and the temperature can be known without complicated calculations or table lookup. The on-chip 12-bit ADC has a minimum resolution of 0.0625°C.

Please tell us your needs

Indasina, a group corporation composed of factories, is committed to a variety of electronic products and the overall customized solutions.

partners 9
partners 8
Partners7
Partners6
Partners5
Partners4
Partners3
Partners2
Partners1
Leave a message Request A Free Quote
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.