Home /


  • TL432AIDBZ

    TI TL432AIDBZ Voltage reference chip SOT-23

    TL431LI/TL432LI is a pin-to-pin replacement of TL431/TL432. TL43xLI provides better stability, lower temperature drift (VI(dev)) and lower reference current (Iref), thereby improving system accuracy.TL431 and TL432 devices are three-terminal adjustable shunt regulators, which can meet the specified thermal stability in the applicable automotive, commercial and military temperature ranges. The output voltage can be set to any value between Vref (approximately 2.5V) and 36V through two external resistors.

    Hot Tags : TI TL432AIDBZ TI Voltage reference chip Voltage reference chip


    TI SOT-256 TMP102AIDRLR Temperature Sensor

    The TMP102 device is a digital temperature sensor, which is very suitable as a replacement for NTC/PTC thermistors that require high precision. The device can provide an accuracy of ±0.5°C without calibration or without external component signal conditioning. The device temperature sensor is a highly linear product, and the temperature can be known without complicated calculations or table lookup. The on-chip 12-bit ADC has a minimum resolution of 0.0625°C.

    Hot Tags : TMP102AIDRLR TI Temperature Sensor

  •  H5TQ2G63GFR-RDC


    The H5TQ2G83GFR-xxC, H5TQ2G63GFR-xxC,H5TQ2G83GFR-xxI, H5TQ2G63GFR-xxI, H5TQ2G83GFRxxL,H5TQ2G63GFR-xxL,H5TQ2G83GFR-xxJ,H5TQ2G63GFR-xxJ are a 2,147,483,648-bit CMOS Double Data  Rate III (DDR3) Synchronous DRAM, ideally suited for the main memory applications which requires large  memory density and high bandwidth.


  •  SN74HC125DR

    TI SN74HC125DR SOIC-14 15mil driver

    Description  This device contains four independent buffers with  3-state outputs. Each gate performs the Boolean  function Y = A in positive logic.

    Hot Tags : TI SN74HC125DR TI driver

  • TLC549CDR

    TI SOP8 TLC549CDR Communication IC

    8-BIT ANALOG-TO-DIGITAL CONVERTERS WITH SERIAL CONTROLThe TLC548 and TLC549 are CMOS analog-to-digital converter (ADC) integrated circuits built around an 8-bitswitched-capacitor  successive-approximation  ADC.  These  devices  are  designed  for  serial  interface  with  amicroprocessor or peripheral through a 3-state data output and an analog input. The TLC548 and TLC549 useonly  the  input/output  clock  (I/O  CLOCK)  input  along  with  the  chip  select  (CS)  input  for  data  control.  Themaximum I/O CLOCK input frequency of the TLC548 is 2.048 MHz, and the I/O CLOCK input frequency of theTLC549 is specified up to 1.1 MHz.

    Hot Tags : TI TLC549CDR Communication IC


    TI SOT-23 TL431BIDBZR Voltage reference chip

    The TL431 and TL432 are three-terminal adjustable shunt regulators, with specified thermal stability over  applicable automotive, commercial, and military temperature ranges. 

    Hot Tags : TI chip TI TL431BIDBZR

  • TI TPS61040DBVR 

    TI TPS61040DBVR DC-DC IC SOT-23-5

    The TPS6104x is a high-frequency boost converter  dedicated for small to medium LCD bias supply and  white LED backlight supplies. The device is ideal to  generate output voltages up to 28 V from a dual-cell  NiMH/NiCd or a single-cell Li-Ion battery. The part  can also be used to generate standard 3.3-V or 5-V  to 12-V power conversions.  

    Hot Tags : TI TPS61040DBVR   DC-DC IC

  •  TLC5941RHBR

    TI VQFN-32_EP TLC5941RHBR LED driver

    The TLC5941 is a 16-channel, constant-current sink,  LED driver. Each channel has an individually  adjustable 4096-step grayscale PWM brightness variations between LED channels and other LED  Controlled In-Rush Current  drivers. Both grayscale control and dot correction are accessible via a serial interface. A single external  resistor sets the maximum current value of all 16   channels.

    Hot Tags : TI TLC5941RHBR LED driver

  • TCA9534APWR

    TI TSSOP-16 TCA9534APWR Low power input output (I/O) expander

    TCA9534A is a 16-pin device that provides 8-bit general-purpose parallel input and output (I/O) expansion for the two-wire bidirectional I 2C bus (or SMBus) protocol. The device can operate in a supply voltage range of 1.65V to 5.5V, allowing the use of various devices. The device supports 100kHz (standard mode) and 400kHz (fast mode) clock frequencies. When switches, sensors, buttons, LEDs, fans, and other similar devices require additional I/O, I/O expanders (such as TCA9534A) can provide a simple solution.

    Hot Tags :  Low power input output (I/O) expander TI TCA9534APWR 


    TI Operational Amplifier LM321LVIDBVR

    The LM3xxLV family includes the single LM321LV,  dual LM358LV, and quad LM324LV operational  amplifiers, or op amps. The devices operate from a  low voltage of 2.7 V to 5.5 V.  

    Hot Tags : Operational Amplifier TI LM321LVIDBVR

  • MT41K256M16LY

    Micron MT41K256M16LY DDR3L SDRAM

    Description  DDR3L SDRAM (1.35V) is a low voltage version of the  DDR3 SDRAM (1.5V).

    Hot Tags : DDR3L SDRAM SDRAM MT41K256M16LY

  •  M12L64164A-5TG2Y


    1M x 16 Bit x 4 Banks   Synchronous DRAMGENERAL DESCRIPTION   The M12L64164A is 67,108,864 bits synchronous high data rate Dynamic RAM organized as 4 x 1,048,576 words by  16 bits. Synchronous design allows precise cycle controls with the use of system clock I/O transactions are possible on  every clock cycle. Range of operating frequencies, programmable burst length and programmable latencies allow the same  device to be useful for a variety of high bandwidth, high performance memory system applications.

    Hot Tags : DRAM MEMORY ESMT M12L64164A-7TG

<< 1 2 3 4 5 6 ... 19 >>
[  a total of  19  pages]

Product Categories

New Products

Please tell us your needs

Indasina, a group corporation composed of factories, is committed to a variety of electronic products and the overall customized solutions.

partners 8
Leave a message Request A Free Quote
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.